Repute 2 Update 3

[Geocentrix Support]

Repute 2.0 Update 3 has been released and can be downloaded from the program's updates page http://www.geocentrix.co.uk/repute/update.

Improvements in this release are:

1821 Panels do not realign on opening existing project
1820 Elapsed time reported by PGroupN console underestimates actual time taken to perform calculations
1818 Interpile spacing < 2.5 should issue warning not critical error
1817 PGroupN console reports wrong information in 'Program took' line
1816 Provide better filter in Registration box to prevent invalid licence number being entered
1815 Add green skin under visual appearance
1814 Labels used on F vs depth graphs do not correspond to pile names
1810 Panels do not resize properly after switching desktop
1809 Borehole does not draw correctly
1807 Remove WARNING from About Box: 'no liability is accepted for use of this pre-release software'
1806 Add controls to allow a specific (single) calculation to be run
1805 Build current scenario buttons should be disabled when there are no scenarios or calculations specified
1802 Selection handles for bored pile appear in the wrong place
1800 Update Developer Express controls to Build 47
1799 Order of x, y, and depth parameters pasased to water tables and surcharges is wrong
1797 Remove redundant references from Reference Manual
1796 Corrections needed to Reference Manual
1789 Error 'boost::filesystem::remove' running boundary element analysis
1760 Borehole with multiple layers draws all layers with symbol for top layer only
1755 Screenshot of About box is out-of-date in help system
1754 Screenshot of Repute 2 UI is out-of-date in help system
1730 Cannot get output from Boundary Element Analysis
1723 No results are generated for second Boundary Element calculation in project
1708 Screenshot of About box in help file is out of date
1670 Model factor on resistance is missing from workbook display of Longitudinal ULS results
1669 Inconsistent labelling of symbols in Workbook headings
1619 In the Graph Paper context menu the Save As button is always greyed out
1515 Program does not remember 'Active Load Case' from Repute 1.5
1459 Draw bending moment graphs with data points shown
1456 Bending moment graphs do not specify which moment is shown
1449 Drawing jumps in position on switching from Plan to Elevation view
1429 Program should cleanup temporary files on Documents and Settings folder on shut-down